LORA SX1278 and (Ra-02) SMD Modules 433MHz 10KM COM54, R17

Pin Connections (for Arduino Uno/Nano):LoRa Module Pin                                                           Arduino PinMISO                                                                                Pin 12MOSI                                                                                Pin 11SCK                                                                                   Pin 13NSS (CS)                                                                          Pin 10RESET                                                                              Pin 9DIO0                                                                                Pin 2GND                                                                                 GNDVCC (3.3V)                                                                     3.3V (Important!)Note: The LoRa module operates at 3.3V, so ensure you’re using the 3.3V pin for power. Also, the logic level is 3.3V, so if you are using a 5V Arduino, it’s safer to use level shifters for the SPI pins (although many users get by without them).Libraries and Code: You can use the LoRa.h library by Sandeep Mistry for easy integration with Arduino. Here’s how to install the library and write a basic program to send and receive messages.Step 1: Install the LoRa Library Open Arduino IDE. Go to Sketch -> Include Library -> Manage Libraries. Search for LoRa and install the LoRa by Sandeep Mistry library.Step 2: LoRa Transmitter Code (Sender)#include <SPI.h> #include <LoRa.h> void setup() { Serial.begin(9600); while (!Serial); // Initialize LoRa module Serial.println("LoRa Sender"); if (!LoRa.begin(433E6)) { // Set frequency to 433 MHz Serial.println("Starting LoRa failed!"); while (1); } } void loop() { Serial.println("Sending packet..."); // Send a packet LoRa.beginPacket(); LoRa.print("Hello World"); LoRa.endPacket(); delay(1000); // Wait 1 second between packets } Step 3: LoRa Receiver Code cpp Copy code #include <SPI.h> #include <LoRa.h> void setup() { Serial.begin(9600); while (!Serial); // Initialize LoRa module Serial.println("LoRa Receiver"); if (!LoRa.begin(433E6)) { // Set frequency to 433 MHz Serial.println("Starting LoRa failed!"); while (1); } } void loop() { // Try to parse packet int packetSize = LoRa.parsePacket(); if (packetSize) { // Received a packet Serial.print("Received packet: "); // Read packet while (LoRa.available()) { String received = LoRa.readString(); Serial.print(received); } // Print RSSI (signal strength) Serial.print(" with RSSI "); Serial.println(LoRa.packetRssi()); } }